THE WATER HARDNESS MAP IN RUSSIA IS PRESENTED BELOW:
In regions with very hard water and water of medium hardness, in the case of individual water supply (well), there is a risk of limescale formation.
One millimetre of limescale increases energy costs by 10%. What if there is a layer of limescale of 2-3 millimetres the walls of the devices? That is right; we lost 30% of the heat. All this reduces the service life of the devices. The equipment breaks down and is often not repairable.
WaterMill can remove any limescale and prevent it from reappearing.
The temperature stress
of the heat exchanger metal
from contact with the flame increases.
As a result, destruction
may occur (melt or burst).
Under the limescale layer,
corrosion processes gradually
develop, which also lead
to premature failure
of the equipment.
Limescale destroys equipment,
of the washing machine.
Because it is not profitable for companies that sell and service boilers and water heating equipment, as it will not allow them to receive money for regular maintenance and repair.
Structurally, the device is a microprocessor-controlled generator of high-frequency electromagnetic pulses with a variable frequency level of the radio signal.
In this case, microcrystals suspended in water are formed with a size of several microns. These microcrystals no longer stick to the walls, do not stick to and do not settle to the bottom. They are not visible to the eye; they hang in a mass of water and, if necessary, can be filtered. Thus, the device prevents the formation of limescale.
|The maximum diameter of the pipeline in which water is processed||up to 40 mm||up to 60 mm||up to 60 mm||up to 38 mm||up to 60 mm|
|Power consumption||1.2 W||5 W||more than 5 W||1.2 W||1.5 W|
|Maximum allowable water hardness for use||up to 20 mg/l||up to 11 mg/l||up to 9,5 mg/l||up to 10 mg/l||up to 10 mg/l|
|Installation method||On the pipe||On a wall with winding wires on a pipe||On a wall with winding wires on a pipe||On the pipe||On a wall with winding wires on a pipe|
|Term of use||25-30 years||25-30 years||up to 25 years||up to 25 years||25-30 years|
|Price (rub)||12 450||12 500||7 400||35 800||18 500|
A prepared heating element was installed in the water heater from a water heater that worked for 2 months (protocol of 03.22.17)
After 3 months of testing, the limescale on the heating element became soft; it can be removed by hand, wiping the surface of the heating element without applying much effort. The heating element almost all cleared. The magnesium anode dissolved almost half (5 months have passed since the first inclusion).Download the entire protocol (report) (.pdf)
I want to leave a review about the device protecting from the watermill limescale.
I bought it in May, and installed in June. During this time, June-December, I experienced minor problems: all the limescale came out of the pipes, it was very inconvenient and I was advised with a strainer to catch this limescale.
As a result, there is no more limescale.
I put your device on the inlet pipe a year ago immediately upon arrival. I live in a private house. I do not know the problems with limescale. I went through the first boiler service and was surprised. Everyone in the district complains about the poor quality of water, and my boiler is clean.
Thank you very much for the original domestic product!